miimac7
Shiny_Rock
- Joined
- Jan 16, 2007
- Messages
- 112


The three bands stacked together are 8mm, which is a bit too wide on my finger. The emerald cut band is 4cts and 4mm wide, a bit too narrow. One round diamond band and the emerald cut band is 6mm wide which looks good width wise, so the goal width is between 5.5-6mm. The emerald cut band will be reset to a half bezel with stones going vertical, then the round diamonds will be placed on both sides of the shank.
Pictures:
1. the existing bands: 2 round diamond bands (1ct) and one emerald cut band (4ct)
2. A picture of the emerald cut with red dots where the round diamonds would go on each side of the ring. So when it on face down you see emeralds and from either side you see round.
Thoughts??