Hi guys,
I'm hoping to get some advice on a diamond for an engagement ring. I did some research on the forum and followed the criteria below for the diamond:
diamond parameters
Table 54-58%
Depth 60-62.4%
Pavilion Angle 40.6-40.9 degrees
Crown Angle 34-35 degrees (up to 35.5 or perhaps even 36 with a 40.6 pavilion)
And came up with this one:
Can someone give me some advice on how this looks? To me the cut doesn't look perfectly symmetrical in the middle (table) but am I being too picky?
Thank you very much in advance!
I'm hoping to get some advice on a diamond for an engagement ring. I did some research on the forum and followed the criteria below for the diamond:
diamond parameters
Table 54-58%
Depth 60-62.4%
Pavilion Angle 40.6-40.9 degrees
Crown Angle 34-35 degrees (up to 35.5 or perhaps even 36 with a 40.6 pavilion)
And came up with this one:
Can someone give me some advice on how this looks? To me the cut doesn't look perfectly symmetrical in the middle (table) but am I being too picky?
Thank you very much in advance!