loriken214
Ideal_Rock
- Joined
- Oct 21, 2007
- Messages
- 4,348
loriken214|1300150374|2871896 said:I know there must be a source for NEW rose cut diamonds since they are appearing more and more in new jewelry. Any idea where I can find some?
I'd love to see photos of jewelry, too. Thank you!!!
Lori
Laughinggravy0|1300287856|2873171 said:Hi, here's my lovely .80 rose cut pendant from James Meyer. I love rose cuts, they look fab in low lighting.
Gothgrrl|1311644875|2976782 said:Here is my new rose cut ring.
heliotrope|1314402001|3000927 said:just a quirky question for those of you with rose cuts - are they see through?? in that they show your finger from behind the stone??
I am keen to get a new one set into a ring (around 6mm to 7mm in diameter - however that equates into cts) but I wonder how it will look with a larger stone
I know they are flat on one side - which is actually attractive as I want the stone to sit flat and low as possible - but I am unsure how they look from the top down
I also want to get some studs with double bezels and fine milgrain - as I have tiny lobes and don't want massive diamonds hanging off my ears - but again I wonder if I should have them made with solid backs - so the bar and post don't show through??
I have seen lots of old rose cuts - which can be charming in their wonky and clouded manner - as well as overtly included stones (think the etsy options) but I am looking at neat and clean stones cut recently in VS1 or above
any thoughts or pics from owners of rose cuts out there??
stci|1314795079|3006199 said:heliotrope|1314402001|3000927 said:just a quirky question for those of you with rose cuts - are they see through?? in that they show your finger from behind the stone??
I am keen to get a new one set into a ring (around 6mm to 7mm in diameter - however that equates into cts) but I wonder how it will look with a larger stone
I know they are flat on one side - which is actually attractive as I want the stone to sit flat and low as possible - but I am unsure how they look from the top down
I also want to get some studs with double bezels and fine milgrain - as I have tiny lobes and don't want massive diamonds hanging off my ears - but again I wonder if I should have them made with solid backs - so the bar and post don't show through??
I have seen lots of old rose cuts - which can be charming in their wonky and clouded manner - as well as overtly included stones (think the etsy options) but I am looking at neat and clean stones cut recently in VS1 or above
any thoughts or pics from owners of rose cuts out there??
Rose Cut as all diamonds need light! I don't think It's a good idea...