Please help with finalizing five stone ring CADs

[2Neesers]

Hello,
DK is making me a 1.5ct five stone ring. I’m very excited about it, but am not good at reading CAD’s and could use help finalizing them to make sure the finished ring looks like my inspiration ring:




These are the first drawings I received:


The band looked too narrow where it meets the first set of prongs, so I asked for it to be widened. I also asked for a thin matching plain band to be made in case I wanted to wear it as an alternative e-ring/wedding band set.
These are updated drawings I was sent:

Any help getting this just right would be greatly appreciated!

 

[prs]

If you look at the bottom right drawing in both CADs you will see the width of the band at the bottom was increased from 1.83 to 2.59mm. Also, on those same bottom right drawings, whilst there are no dimensions shown, you can see the top of the band was also widened where it meets the first set of prongs.

It looks like the new thin band is designed such that it will not rub on the diamonds, so they took care of that potential issue for you.

The diamonds look like they are spaced closer together than your inspiration but to me, that's a good thing. Other than that it looks like the DKJ design is pretty much spot on to your inspiration!

 

[2Neesers]

Thank you for your help @prs . I’m glad to hear it looks pretty much spot on!