BAS2348
Rough_Rock
- Joined
- Aug 4, 2015
- Messages
- 63
Hi all,
At the suggestion of mrs-blop, I emailed David Klass (he has been so responsive) and finally have the first set of CADs for our custom ring project. I am not too familiar on evaluating CADs, or how high/low the setting should be - I am taking into consideration that she is a nurse and so the setting cannot be too high.
She chose to go with a channel set style for the shank, and a trellis design. David was able to find a pair of 0.26 ct half-moons for the sides, which I think is a good ratio against our 0.69 ct cushion center. He did offer to find smaller ones if needed.
Thank you!
At the suggestion of mrs-blop, I emailed David Klass (he has been so responsive) and finally have the first set of CADs for our custom ring project. I am not too familiar on evaluating CADs, or how high/low the setting should be - I am taking into consideration that she is a nurse and so the setting cannot be too high.
She chose to go with a channel set style for the shank, and a trellis design. David was able to find a pair of 0.26 ct half-moons for the sides, which I think is a good ratio against our 0.69 ct cushion center. He did offer to find smaller ones if needed.
Thank you!