Panhandler80
Rough_Rock
- Joined
- Jun 27, 2011
- Messages
- 19
I have done quite a bit of poking around, but have not seen this addressed, so I figured I'd post.
Really enjoy the site and it has helped me a lot in the process.
I have a round 1.19c diamond picked out (6.79 x 6.82mm).
I'm doing this over the internet and i THINK i have a setting picked out.
Setting is 3mm wide at the top, with 7 three pointers on each side of the center stone.
QUESTION:
Setting width / center stone width is 44.11%
Do you guys and gals think that this band is going to be too chuncky for my diamond?
44% looks about like the UPPER image below.
**edited by moderator. please upload photos to forum directly to avoid broken links**
Really enjoy the site and it has helped me a lot in the process.
I have a round 1.19c diamond picked out (6.79 x 6.82mm).
I'm doing this over the internet and i THINK i have a setting picked out.
Setting is 3mm wide at the top, with 7 three pointers on each side of the center stone.
QUESTION:
Setting width / center stone width is 44.11%
Do you guys and gals think that this band is going to be too chuncky for my diamond?
44% looks about like the UPPER image below.
**edited by moderator. please upload photos to forum directly to avoid broken links**