Thanks in advance for your advice. I contacted a PS vendor and asked for a full eternity band (ring size 5.75) + thin/dainty shank + low profile. This will be in platinum. I just received the CAD renderings for the setting, but I now I need some advice:
1) Will the shank being under 2mm cause problems in the future? I hear these pave type settings are prone to diamonds falling out, etc.
2) Is 7.26mm high prong/basket considered low? I just know my gf wants a low setting. Should I have the shank portion go up and meet the basket? Ala the Caroline at WF http://www.whiteflash.com/engagemen...e-solitaire-engagement-ring-by-vatche-251.htm or is the current design adequately considered low by most folks?
3) Azures! Will these holes in the shank hurt the sturdiness of the piece? I don't want to micromanage anyone but in combination of the <2mm shank, I'm slightly concerned, ha. Plus it'd be nice to have something engraved inside maybe (it'd have to be tiny tiny, ha)
1) Will the shank being under 2mm cause problems in the future? I hear these pave type settings are prone to diamonds falling out, etc.
2) Is 7.26mm high prong/basket considered low? I just know my gf wants a low setting. Should I have the shank portion go up and meet the basket? Ala the Caroline at WF http://www.whiteflash.com/engagemen...e-solitaire-engagement-ring-by-vatche-251.htm or is the current design adequately considered low by most folks?
3) Azures! Will these holes in the shank hurt the sturdiness of the piece? I don't want to micromanage anyone but in combination of the <2mm shank, I'm slightly concerned, ha. Plus it'd be nice to have something engraved inside maybe (it'd have to be tiny tiny, ha)