Sapphire127
Rough_Rock
- Joined
- May 19, 2020
- Messages
- 28
Hi everyone,
I am considering changing the setting of my 9.25x6.65 sapphire. It is currently set in a halo, but I am considering getting it changed to a three stone with two trillion cut diamonds beside the sapphire. I like yellow cold, but I think I’d change it to platinum if I reset it to look better with the trillions. It’s an engagement ring so I’m a bit concerned that the halo makes it look more like a RHR than an engagement ring. Additionally, I think the sapphire sits a bit weirdly on top of the halo instead of within the halo. I’m pretty new to this so any suggestions for the setting are greatly appreciated!
I am considering changing the setting of my 9.25x6.65 sapphire. It is currently set in a halo, but I am considering getting it changed to a three stone with two trillion cut diamonds beside the sapphire. I like yellow cold, but I think I’d change it to platinum if I reset it to look better with the trillions. It’s an engagement ring so I’m a bit concerned that the halo makes it look more like a RHR than an engagement ring. Additionally, I think the sapphire sits a bit weirdly on top of the halo instead of within the halo. I’m pretty new to this so any suggestions for the setting are greatly appreciated!