emeraldgalB
Rough_Rock
- Joined
- Dec 20, 2012
- Messages
- 53
I ti s lovely!
A profile view of the diamond would be helpful along with a clearer close up if you can get it. I find it easier to hold my phone out a little farther and then zoom in instead of holding the camera close up.
It's still hard to see clearly but I'm going to guess that it is an OEC...but maybe with a slightly larger table than usual? I see a what looks like a small open culet and flowery facets under the table but that could still be a transitional.
I would not want to guess at ct weight without at least measurements of the top of the diamond. It could only be a guess/estimate at best unless you have the diamond unset.
Is the ring platinum? If you haven't already I would take it to a jeweler to check those fishtail prongs. Some of them look a bit flattened and that can happen with wear. You definitely do not want to lose such a precious heirloom!
It is beautiful.
I hope someone with more experience (and maybe younger eyes!) will chime in if I'm incorrect.
It’s an OEC.
If you can get diameter and depth measurements an estimated weight can be calculated.
Looks like similar to my OEC, did you figure out carat weight?
Interesting, I would have guessed a little over a carat. It looks big to me. It’s very pretty!Hard to accurately say because difficult to guesstimate depth/length of diamond bc of the setting... but seems to be about 5.5 mm across. Im guessing its about
1/2carat.
Lovely OEC and fishtail prong setting! They’ve got a good amount of wear left in them.
It’s a very pretty ring