I''m currently looking for an emerald cut stone with a rather extreme l/w ratio, 2 and above would be fine. I found one stone on blue nile which sounds interesting:
carat: 1.02
colour: F
clarity: vvs2
8.48x4.15x2.95mm
depth 71,1%
table 65%
cut, however, is only good. I want the stone in a bezel setting; will this be fine? could I even consider a fair cut, for which union offers some otherwise interesting stones?
and why are bezel settings so rare for emeralds?
thanks in advance for any advice!
carat: 1.02
colour: F
clarity: vvs2
8.48x4.15x2.95mm
depth 71,1%
table 65%
cut, however, is only good. I want the stone in a bezel setting; will this be fine? could I even consider a fair cut, for which union offers some otherwise interesting stones?
and why are bezel settings so rare for emeralds?
thanks in advance for any advice!