Diamcalc and Gemadvisor request please

[ryusrock]

Hi, would someone be kind enough to create a Diamcalc file, I''d like to know the Gemadvisor results from my Sarin report.

Sarin:

1.32ct

Diameter 7.105mm
Total Depth 60.8% 4.32mm
Crown height 14.4% 1.02mm
Crown Angle 33.5
Table diameter 58% 4.14mm
Pavillion depth 43.9% 3.12mm
Pavillioin Angle 41.3

Girdle medium

Thank you

 

[belle]

it would not be an accurate representation of your diamond. there are too many variables that would have to be assumed. if you had a 3d scan, it could be done with some meaning, otherwise it''s like asking someone who has never seen you to paint a portrait.

 

[ryusrock]

Date: 5/7/2007 9:03:41 AM
Author: belle
it would not be an accurate representation of your diamond. there are too many variables that would have to be assumed. if you had a 3d scan, it could be done with some meaning, otherwise it''s like asking someone who has never seen you to paint a portrait.

I understand that it would not be 100% accurate however, I would still likt to get a DiamCalc and Gemadvisor results with my Sarin report specs.

If someone could help me out, it would be much appreciated.

Thanks again.

 

[JohnQuixote]

Hi ryusrock,

I remember our discussion from this thread: https://www.pricescope.com/community/threads/scrutenize-my-stone.61374/page-2

The updated specs are going to be nearly-identical to what you had before. What Belle has said above is entirely valid. I only created the graphic in your last thread because you actually had an ideal-scope: That meant I could determine a wee bit more about minor facets and optical symmetry than I could 'blind.' That still leaves a lot of guesswork. I'm at fault if I didn't explain that very well before.

I've created some graphics to illustrate this and I'll post them in your other thread, linked above, for sake of continuity.

Cheers,

 

[ryusrock]

Hi John,

I understand the slight variations, but if youcould, I actually wanted the Gemadvisor performance results.

Much appreciated.