pancake
Brilliant_Rock
- Joined
- Jan 7, 2010
- Messages
- 1,652
Hi good peeps of PS, I am looking to have an antique-style 0.7ct marquise set into a single station bezel chain bracelet.
My question is around flipping.
1. Will a deeper bezel (like the one on the pictured amethyst help to reduce it? My stone is 8.8mm x 4.4mm x 2.9mm, so it isn't super deep but reasonably sizable for a bezel on a bracelet.

2. On my 5.75" wrist, what length should the bracelet be? 6"? I am assuming that if it's tighter to the wrist it will possibly flip (and rotate around my wrist) less?
3. Does the orientation of the rings that attach bezel to chain make any difference? Eg this diamond one below - the rings are set perpendicular to the bezel. Would setting them lower on the bezel also help?


Help much appreciated!
My question is around flipping.
1. Will a deeper bezel (like the one on the pictured amethyst help to reduce it? My stone is 8.8mm x 4.4mm x 2.9mm, so it isn't super deep but reasonably sizable for a bezel on a bracelet.

2. On my 5.75" wrist, what length should the bracelet be? 6"? I am assuming that if it's tighter to the wrist it will possibly flip (and rotate around my wrist) less?
3. Does the orientation of the rings that attach bezel to chain make any difference? Eg this diamond one below - the rings are set perpendicular to the bezel. Would setting them lower on the bezel also help?


Help much appreciated!
Last edited: