by Diamondnewb12 » Sep 6, 2019 So I saw this band that Starsgem had done before and I love it. I would like to change the “height” of the band closer to 3mm ( lower if possible but don’t think it can be with the 5mm stones) so it has a lower profile. I would also like to change the widest part of the band to maximum 6mm, ideally it would be closer to 5mm range. Is that at all possible to do with the stones sizes being how they are now? Would those measurements work if I had them change the gallery( the underside of the band)? Would I have to change the stone sizes all together to get the lower profile and smaller width. I can’t seem to get them to understand and on top of that communication isn’t very good as well. I am working with Alisa? (Starsgem17) Any and all suggestions welcome, I would love to just give them some measurements so things would be clear. Thank you!