- Joined
- Jan 8, 2014
- Messages
- 1,909
Hi Everyone,
I have been working with DK on CADS for a three stone diamond ring, and while they look great to me, I am wondering if there is anything I am overlooking that should be adjusted before the final piece is made?
The first set of CADS below were sent to me, then I asked to have the wires on the center stone gallery thinned a bit and also decided to add graduated bright cut pave to the shank to add more finger coverage on my Size 8 finger. He said it would be best to widen the shank a little as seen in the second CADS to better fit the pave diamonds. I'm including both drawings below since there are some measurements on the first that don't show on the second, like the off the finger height. Any input is appreciated
I have been working with DK on CADS for a three stone diamond ring, and while they look great to me, I am wondering if there is anything I am overlooking that should be adjusted before the final piece is made?
The first set of CADS below were sent to me, then I asked to have the wires on the center stone gallery thinned a bit and also decided to add graduated bright cut pave to the shank to add more finger coverage on my Size 8 finger. He said it would be best to widen the shank a little as seen in the second CADS to better fit the pave diamonds. I'm including both drawings below since there are some measurements on the first that don't show on the second, like the off the finger height. Any input is appreciated
300x240.png)