Question about AGA grading calculator....

[dianeflys]

I''ve run into several times using the DIY grading calculator by AGA. Re: a diamonds measurements....if, on the certificate they are given as follows: 6.76-6.79 x 4.15mm...when I input those measurements into the calculator as 6.76(L) 6.79(W) 4.15(D) along with the other information, I get a response of ''Please enter a width that is less than or equal to the length''. So do I change the width to equal the length (6.76) or am I putting the numbers in the wrong place?

Thanks all!!

 

[stone-cold11]

Yap, length is the largest dimension.

 

[dianeflys]

Thanks for the quick answer, Stone Cold!

(I''m such a linear thinker...... I thought the numbers, as given on a certificate, should be intered into the calculator in that order) Thanks again!