- Joined
- Nov 3, 2009
- Messages
- 7,589
Date: 1/11/2010 4:41:03 PM
Author: exturkconner
Real deal photographers will often tell you to never use flash on anything. If the subject doesn''t have enough ambient light you move light in and if you can''t then you don''t shoot. The problem with using a flash in a stone is that stones are made to flash and sparkle and a flash is a bright flickering light. Usually that''s going to cause sparkles and sparkles are going to ruin your focal point so the camera''s pictures will look fuzzy.
They have ebay seller photography kits. It''s basically a little white tent with a platform and two light sources in it. The light is pointed to the white so it deffers as opposed to be blinding direct light. Alot of folks like that sort of shooting environment. To me it''s a bit to sterile but some like it.
Try placing a white sheet (3x5 card) in front of the flash and angling up. This bounces the flash away from the gem. Not sure what this does to automatic exposure, but it gets the flash illumination away from the gem, with the camera still on full auto.Date: 1/11/2010 9:44:41 PM
Author: lavatea
I hate flash on any pictures. But my camera is very stubborn, and unless I set it in almost completely manual mode, it generally pops up the stupid flash.
Date: 1/11/2010 6:15:37 PM
Author: zeolite
In general, using flash in gemstome photography is a bad idea. The light rays from flash are very parallel, and the lighting you want, is very wide angle diffused light, such as an overcast day.
That eBay lighting tent would do well for photographing entire pieces of jewelry, mainly metal (gold or platinum), but it would not do well for gemstones.
The reason is, using the tent, the light comes in 90 degrees from the sides, and the camera and gem is in the front. Gemstones are cut with the intention that light enters the front (the table) and reflects back to the viewers eyes. Light entering the gemstone from the side, would not enter the gem, it would be reflected toward the back.
Here is an old gem photography thread I wrote on this subject.
Thanks Gene for sharing. I have a similar setup too. What do you use as the base surface where your rest your gemstone on?Date: 1/11/2010 10:36:47 PM
Author: PrecisionGem
Here''s my photo setup.
Date: 1/11/2010 11:53:34 PM
Author: Revolution
Oops, I just saw Precisions setup. It looks like it would work way better than my suggestion. In fact, I think I am going to build one of these little beauties for myself!