BAS2348
Rough_Rock
- Joined
- Aug 4, 2015
- Messages
- 63
Hello again everyone,
My SO and I made the decision to start over from scratch with her ER design, a simple solitaire with bright cut pave down 3/4 of the shank similar to these two designs, sans the diamonds on the struts of the second photo:
We just received our first round of CADs, the shank is 1.8mm's wide, the center stone just over 5mm's off the finger, he did mention the pave is not added to the CAD yet, but he will add it in the future. Is this an adequate "low" height or is it too high? I'm not too familiar with how much to add/subtract to let the stone sit low on her hand.
Thanks again! Sorry to be such a pain with all my threads recently
My SO and I made the decision to start over from scratch with her ER design, a simple solitaire with bright cut pave down 3/4 of the shank similar to these two designs, sans the diamonds on the struts of the second photo:
We just received our first round of CADs, the shank is 1.8mm's wide, the center stone just over 5mm's off the finger, he did mention the pave is not added to the CAD yet, but he will add it in the future. Is this an adequate "low" height or is it too high? I'm not too familiar with how much to add/subtract to let the stone sit low on her hand.
Thanks again! Sorry to be such a pain with all my threads recently