Doc_1
Shiny_Rock
- Joined
- Oct 22, 2008
- Messages
- 452
Been on this forum for a while and had a previous work done by Mark for my wife's ER and earrings I turned to Mark again to do an engagement ring as a gift for my daughter Amira (means ... princess), I looked on his website and I saw a ring on his doodle section that I liked, he calls it Orchid ring, and it was supposed to be for a blue lab stone that has an octagonal shape with a halo in platinum accented with red gold, I contacted him and asked him if the CAD of the ring is still available and he said yes, the original project did not go through.
http://mwmjewelry.com/Process/slides/JK_Orchids.html
Fitting the square Princess cut to the octagonal halo was the modification to the original drawing which sets the center stone in a bezel:
The center stone is Solasfera Princess Cut from GOG, 0.71 (4.81 x 4.77 x 3.67mm) that will not suffer from light deprivation a bezel setting may impose:
After having the diamond shipped to MM from GOG he sent me the Drawing and we will proceed with the project for ring size 5.
Mark offered delicate ring but my daughter likes it the way it is...He agrees since it looks good.
We will proceed with the project and will see the final result ...
I expect it to be spectacular like MM always does, above and beyond....!!
http://mwmjewelry.com/Process/slides/JK_Orchids.html
Fitting the square Princess cut to the octagonal halo was the modification to the original drawing which sets the center stone in a bezel:

The center stone is Solasfera Princess Cut from GOG, 0.71 (4.81 x 4.77 x 3.67mm) that will not suffer from light deprivation a bezel setting may impose:

After having the diamond shipped to MM from GOG he sent me the Drawing and we will proceed with the project for ring size 5.



Mark offered delicate ring but my daughter likes it the way it is...He agrees since it looks good.
We will proceed with the project and will see the final result ...
I expect it to be spectacular like MM always does, above and beyond....!!