tweeter8177
Brilliant_Rock
- Joined
- Feb 18, 2013
- Messages
- 571
Hi all!
Some of you may have followed my last thread on getting a 3 stone setting. After talking to multiple vendors, I decided to go with BE. It was a tough decision, but I have worked with them before and they are helping me on a couple of other projects.
I would love some input on the CADs! I loved a Stuller ring (pictures attached) and ultimately was worried about the quality. BE was able to create a similar look. The most important thing to me is the top view, from spacing of the sidestones and tilt of them. The proportions will be a bit different than the inspiration ring. My center stone is 1.01ct (6.45mm) and each of the side stones will be .33ct (4.4mm).
Do the sidestones still look too tilted?
I had them beef up the shank and maybe it is too thick now? It is 2.5mm and tapers to 2mm. The 1st CAD was 1.9mm tapering to 1.5mm.
Do the side baskets look too rounded?
Thanks!
CADs
Inspiration Ring
Some of you may have followed my last thread on getting a 3 stone setting. After talking to multiple vendors, I decided to go with BE. It was a tough decision, but I have worked with them before and they are helping me on a couple of other projects.
I would love some input on the CADs! I loved a Stuller ring (pictures attached) and ultimately was worried about the quality. BE was able to create a similar look. The most important thing to me is the top view, from spacing of the sidestones and tilt of them. The proportions will be a bit different than the inspiration ring. My center stone is 1.01ct (6.45mm) and each of the side stones will be .33ct (4.4mm).
Do the sidestones still look too tilted?
I had them beef up the shank and maybe it is too thick now? It is 2.5mm and tapers to 2mm. The 1st CAD was 1.9mm tapering to 1.5mm.
Do the side baskets look too rounded?
Thanks!
CADs
Inspiration Ring