Did I mess up because of the crown heights?

[Scooba116]

I’m looking at these pairs for studs, but three have crown heights of 14 or 14.5%. I was so focused on the other specs, I didn’t notice. Should I pass on them? Any other problems with these?

https://imgur.com/a/jIhhRVu

I can only find theee of the videos now

1.58 Carat Round Lab Diamond IGI LG593379034 | Ritani

1.58 Carat Round Lab Diamond ID Cut F Color VS2 Clarity with diamond report number IGI #LG593379034

www.ritani.com

1.64 Carat Round Lab Diamond IGI LG579375325 | Ritani

1.64 Carat Round Lab Diamond ID Cut E Color VS1 Clarity with diamond report number IGI #LG579375325

www.ritani.com

1.65 Carat Round Lab Diamond IGI LG572346631 | Ritani

1.65 Carat Round Lab Diamond ID Cut E Color VS1 Clarity with diamond report number IGI #LG572346631

www.ritani.com

 

[0-0-0]

IMO the 2% difference in table sizes and thickness of the arrows are more noticeable than the 1% difference in crown heights. The bigger concern is the CVD strain/grain in the 1.58 F that’s visible in the video.

 

[Scooba116]

IMO the 2% difference in table sizes and thickness of the arrows are more noticeable than the 1% difference in crown heights. The bigger concern is the CVD strain/grain in the 1.58 F that’s visible in the video.

The 56 and 57% would be one pair and the two 58%s would be the other pair.

I wasn’t really worried about the crown height difference being visible on the ear, I just wondered if may that made then less of an ideal cut than I had hoped.

Are you concerned that the strain will affect performance? Will an ASESt reveal if it does?

 

[0-0-0]

Are you concerned that the strain will affect performance? Will an ASESt reveal if it does?

Yes. ASET would not help. Need to be seen in person in various lighting.