CVB Madison (Rivere) CAD thoughts

[mintbark]

What are your thoughts on the CADs for my CVB Madison (previously Rivere). Do you think it’s too thick? Should I do brushed instead of polished? 18kt with natural diamonds.

 

[Kim N]

This is one of my favorite bands! I personally prefer polished to brushed. What is the height off the finger?

 

[Godrick]

Very pretty! By "thick" do you mean tall, as Kim mentioned the height off finger? It looks like it may sit very high up

 

[mintbark]

Yes I mean does it look like it’s too high off the finger.

 

[mintbark]

Cassie says it’s 1.98mm high on the CAD and it’ll be reduced to 1.9mm. Thoughts?

 

[HS4S_2]

It actually sits very low. The cads always seem bulky but it's pretty low.

 

[Rfisher]

Are you wanting to match the band height of something it will be worn next to? 1.9 isn’t high by any means.

i, personally, wouldn’t want it to be made shorter. Especially if it were to be an everyday wear item. YMMV.

my rivière is a bit less than 1.9 tall, I believe.

 

[mintbark]

I have an OEC eternity that’s 1.68mm, I’m just using that as a reference. It feels like a good height and looks good with my current ering.

@HS4S_2 did you ever were yours with your Abby? That’s how I’m planning on wearing it. I haven’t sized it yet so not sure how it’ll look once it’s the proper size.

 

[mintbark]

This is what the 1.68mm eternity and current ering look like.

 

[luckygreen317]

What are your thoughts on the CADs for my CVB Madison (previously Rivere). Do you think it’s too thick? Should I do brushed instead of polished? 18kt with natural diamonds.

It’s absolutely gorgeous and I love the ultrafine milgraining. I am a HUGE fan of a brushed finish. Reducing the shine/reflection of the side of the ring, in my opinion, makes the metal feel rich and the stones are the center of attention.
Either way you go, this will be an amazing band.
Here is my platinum eternity band with double milgraining and brushed finish 2.5MM high (to accommodate the culet of the stone).