SapphireLover
Brilliant_Rock
- Joined
- Jan 12, 2009
- Messages
- 631
I’m getting my 6mm cushion sapphire reset and have just had CADs back and am not good at reading them.
I asked for a fine channel set halo that copied the square shape of the stone (like in the top two pictures). I wanted it with a delicate bezel/ prongs like in @elle_71125 tsavourite. I wanted the side profile to be like the bottom right, with a “floating” open gallery to let in lots of light.
I had asked for 1.3mm diamonds, but the final ring has come back with a 9.9mm diameter and I worry this would be quite large and if I should reduce to slightly smaller? My stone is quite deeply cut and I am thinking of asking the head to be raised a tiny bit too, maybe to 6mm?
Any other comments would be welcome, thank you!
I asked for a fine channel set halo that copied the square shape of the stone (like in the top two pictures). I wanted it with a delicate bezel/ prongs like in @elle_71125 tsavourite. I wanted the side profile to be like the bottom right, with a “floating” open gallery to let in lots of light.
I had asked for 1.3mm diamonds, but the final ring has come back with a 9.9mm diameter and I worry this would be quite large and if I should reduce to slightly smaller? My stone is quite deeply cut and I am thinking of asking the head to be raised a tiny bit too, maybe to 6mm?
Any other comments would be welcome, thank you!