Thoughts on these ideal cuts please?

[Garry H (Cut Nut)]

@Garry H (Cut Nut) Going along with that logic, would it be better to chose a diamond with more inclusion types than just one or two grade defining inclusion(s) when shopping for a SI1 (or perhaps SI2) stone? Thanks! Ahh...I need a "cheat sheet" that show me what are the more "preferred" inclusions....

Over simplification. But can work often.

 

[Lana S]

As you can see, there are a couple of feathers right near the edge.. I'm still 50/50 on whether I should pick this one, or the one with the more visible crystal inclusions nearer to the table...

 

[bmfang]

@Lana S, wasn't able to really clearly see the inclusions in the previous photos you posted of the AGS reports. Have been looking at the WF inventory list trying to find these two stones (looked at all combos which have similar carat weights, colour gradings and clarity gradings and haven't been able to find either of these stones). What are the AGS report numbers?

The feathers aren't that bad along the girdle. Like Garry has said, you could request that WF set the stone so that the feathers are not under a prong, but next to them (so you can avoid any additional stress if the prong was directly over them). Also would depend on what type of setting you are looking at.

 

[Lana S]

@bmfang - sorry I should've clarified I slightly tweaked the specs of stones:
http://www.agslab.com/pdf_sync_reports/104091827007-PGRH.PDF
http://www.agslab.com/pdf_sync_reports/104091827001-PGRH.PDF