Thin Diamond Bands

[that_someone_special]

Anyone know how thin diamond bands can be made? I''m thinking less than 2mm .. is that too small?
I''m thinking a very thin RB band, either eternity or 3/4ths ... and not channel set!

Anyone have anything similar or know who sells them?

Just thinking

 

[neatfreak]

They can be made less than 2mm. Ritani has some, Leon Mege makes them, and a few of the signed pieces ones might be that thin. Tiffany of course has some too. But it is really important to note that the thinner it is the more likely it is to bend. So it needs to be babied a bit.

And if you want to wear this on it's own make sure to check it out in person first. It's reaaaaaaally thin and looks better as a stacker IMO.

 

[clop]

I have a 1.8 mm Leon. I was deciding between 1.8 and 1.6 mm at the time. I love my ring (wedding band), it''s the perfect width for me. At first I was super careful with it, but now I forget it''s on my finger. There are times when I knock it or abuse it accidentally, but when I check, it''s fine.

Ditto to neatfreak''s suggestion of trying them out first. I found many styles I liked over and under 2 mm, and they did NOT complement my finger at all.

 

[that_someone_special]

Thanks for the input! I was actually thinking for wedding bands, like two of them, one of each side of the engagement ring .. I will keep looking.

 

[Upgradable]

The one is my avatar is 1.4mm from Beverley K. The profile is higher to give strength that is lost with the thin width.

 

[Tacori E-ring]

What about sheldon speyer?

 

[Efe]

Trying to add a picture of my 2 Leons and engagement ring...