Shared Prong Eternity Ring

[Maggie May]

Hello All

This is my first post so please be gentle

I''m looking to buy a shared prong eternity ring but not sure about what size or who to buy it from.

I also wear a 2mm cushion fit plat wedding band and a 2mm milgrain diamond band which is also plat. I''''d like to wear the shared prong in the middle. As in:



I''m a size 5.5.

I''d like to wear them stacked as I usually wear my two rings together at the moment.

I''d love some of you to chime in and tell would a 3mm or 3.5mm be the better option ?

I''d also like a lower profile ring but I''m unsure which vendor would suit what I''m after. I''m such a novice I don''t really even know where to start but I don''t want to make a big mistake with my decision, so I thought it best to ask the experts who have gone down this road before

. The only place I''ve even had a peek into is bluenile, but I think there might be a bigger choice out there which I don''t know about.

I''d be very grateful for some advice

x Maggie

Pictures would be lovely too .. am I pushing it

 

[tyty333]

I think I would go smaller just to help keep the height off your finger lower.
Here is one from the facets collection. It is 3.1m wide and 2.6 m from finger to top.

http://www.facetscollection.com/item.cfm?item_id=5115

Here is one that is 2.3 m from the top of finger (2.4 mm wide)

http://www.facetscollection.com/item.cfm?item_id=4200

These 2 are in platinum. If you go smaller in carat weight then you get lower on
your finger but I''m sure there is a certain total carat weight that you are looking
for but you didnt mention.