Seeking advice on position of inclusion

[bryantwk]

This is a .60, F, VS2, ideal cut.

It is eye clean, but I am wary of inclusions on the table which I think have a higher chance of causing a 'dull' spot on the diamond if seen at the right angle/lighting conditions.

Should I be concerned? I'm still learning the ropes so any input will be appreciated!

Also, what type of an inclusion is this?

 

[slg47]

what does the grading report say?

 

[stone-cold11]

Which lab graded the stone?

Post the grading report number.

 

[bryantwk]

Here is the report:

http://agslab.com/reportTypes/pdqdf.php?StoneID=104045708084&Weight=.6&D=1

I just realised the report specifies the type of inclusion.

Thanks!

 

[0-0-0]

As long as the crystals are not dark, I doubt it'll be an issue. I bought an AGS VS2 with clear/white crystals under the table as the only inclusions, and it looks eye clean to me at as close as 3 inches. Sometimes in diffused lighting I think I can spot the largest crystal at 3 inches, but it really strains my eyes.

 

[stone-cold11]

Ditto, should be fine with a VS2, especially at that size. Remember this pic is enlarged how many times on your display. It only has a diameter of 5.4mm.