Ring Size when Stacking Rings

[alloamie]

Hellooo

I went ahead and ordered an eternity band from SP. Now I''m worried that I should order a larger size than my actual finger size since I''ll be stacking with my 2.5mm wedding band & 2.5mm ERing.

My WB is 4.5, my ER is 4.25.
My ER fits perfectly, the WB is slightly loose and fits over my knuckle very easily. The ER is hard to slide over my knuckle. I ordered the WR in 4.5 since the place I got it from didn''t do quarter sizes.

I ordered the eternity band in a 4.25 - should I up it to 4 3/8 or 4.5?
Since my ER is snug at 4.25 - will the two rings together be too tight?

I know there isn''t a real "answer" to this question - but I appreciate any input/advice!
Thanks in advance!

 

[neatfreak]

I think with stacking you need to go a bit bigger, my ering is 5.5, my WB is a 6, and anything I stack with it usually is a 6. But it depends on how you like your rings. I like mine looser.

 

[honey22]

I would err on the side of caution and go a 4.5.

 

[MMT]

MIne are the same size and they both fit fine

 

[HeartingDiamonds]

I, too would suggest going slightly bigger. When stacking, the last stacked ring will sit on the most fleshy area of the finger versus the very end, where the finger is less fleshy and hence thinner.

Hope I''m making sense

- English is not my first language and I sometimes (ok, often!) struggle with words.

 

[neatfreak]

Date: 11/13/2008 10:07:23 AM
Author: HeartingDiamonds
I, too would suggest going slightly bigger. When stacking, the last stacked ring will sit on the most fleshy area of the finger versus the very end, where the finger is less fleshy and hence thinner.


Hope I'm making sense

- English is not my first language and I sometimes (ok, often!) struggle with words.

I didn't even think of that. Good point! And I would never guess that your first language wasn't English!