Hi Everyone!
I''ve been lurking and reading PS for a month up until now, shopping for a (hopefully) sparkly engagement diamond. =D
A huge thank you to all of the advice and knowledge you have shared! I have almost decided on one, but it has a green scratch on one side of the table (I''m attaching a picture, hopefully it will show up okay)
Round 1.86ct E VS1,
AGSL report:
depth: 61.3
table: 56.7
girdle: 1.3 to 3.8
crown angle: 34.5
pavilion angle: 40.9
There is also a GCAL report with different measurements: table: 57, depth: 61.1, culet: 0.4, crown: 34.4, pavilion: 40.8
Should I worry about the green scratch or the feather?
I also wasn''t sure if the optical symmetry and optical brilliance were good or not. Any advice or general comments are most appreciated and welcome.
Thank you all so much, it is quite an learning experience
-H

I''ve been lurking and reading PS for a month up until now, shopping for a (hopefully) sparkly engagement diamond. =D
A huge thank you to all of the advice and knowledge you have shared! I have almost decided on one, but it has a green scratch on one side of the table (I''m attaching a picture, hopefully it will show up okay)
Round 1.86ct E VS1,
AGSL report:
depth: 61.3
table: 56.7
girdle: 1.3 to 3.8
crown angle: 34.5
pavilion angle: 40.9
There is also a GCAL report with different measurements: table: 57, depth: 61.1, culet: 0.4, crown: 34.4, pavilion: 40.8
Should I worry about the green scratch or the feather?
I also wasn''t sure if the optical symmetry and optical brilliance were good or not. Any advice or general comments are most appreciated and welcome.
Thank you all so much, it is quite an learning experience
-H
