Looking at buying a 1.2, G, VS2 round brilliant. Brilliance being the most important factor to me as I plan on putting it in a bezel setting and I know that is also going to cost me a little brilliance. It showed up as a 0.6 (although i guess this would need to be adjusted based on thin girdle) on the HCA, but because that is just
. Depth %: 60.6
. Table %: 55.7
. Crown Angle: 34.6
. Crown %: 15.4
. Star : 53
. Pavilion Angle: 40.6
. Pavilion %: 42.6
. Lower Girdle %: 77
. Girdle: Thin
. Measurements: 6.91-6.93X4.20
. Polish: Excellent
. Symmetry: Excellent
. Culet: Pointed
. Fluorescence: Negligible
The girdle is thin, but if it is bezel set I should have to worry about the girdle chipping, correct? Any input on interpretting these idealscope/aset images would be appreciated.
. Depth %: 60.6
. Table %: 55.7
. Crown Angle: 34.6
. Crown %: 15.4
. Star : 53
. Pavilion Angle: 40.6
. Pavilion %: 42.6
. Lower Girdle %: 77
. Girdle: Thin
. Measurements: 6.91-6.93X4.20
. Polish: Excellent
. Symmetry: Excellent
. Culet: Pointed
. Fluorescence: Negligible
The girdle is thin, but if it is bezel set I should have to worry about the girdle chipping, correct? Any input on interpretting these idealscope/aset images would be appreciated.