thewhitecayman
Rough_Rock
- Joined
- Apr 10, 2015
- Messages
- 1
Hello Everyone!
This is my first post and was hoping for everyone's input on this diamond I'm considering for the engagement ring.
It's:
1.45 round F color VVS2
Cut, Polish, Symmetry are all very good
Depth is 60.4 %
Table is 56%
Crown angle: 33
Pavilion angle: 41.8
Girdle is very thin to thin
Culet is very small
I input the specs and HCA came out to 5 which I'm a bit concerned about. I'm very confused at this point if I should go ahead with this diamond.
Any advice would be much appreciated!
This is my first post and was hoping for everyone's input on this diamond I'm considering for the engagement ring.
It's:
1.45 round F color VVS2
Cut, Polish, Symmetry are all very good
Depth is 60.4 %
Table is 56%
Crown angle: 33
Pavilion angle: 41.8
Girdle is very thin to thin
Culet is very small
I input the specs and HCA came out to 5 which I'm a bit concerned about. I'm very confused at this point if I should go ahead with this diamond.
Any advice would be much appreciated!