Hi!
Does the Asscher below get everyone''s stamp of approval? Video and updated Asset, Sarin, & Gem Advisor reports will be posted tomorrow.
http://goodoldgold.com/diamond/4178
Carat Weight: 1.55ct
Color: F
Clarity: VS2
Polish: Very Good
Symmetry: Excellent
Fluorescence: None
Girdle: 3.32%
Culet: None
Lab Report: GIA
In House: Yes
Width: 6.48mm
Length: 6.49mm
Depth: 4.30mm
Table Percentage: 58.80%
Depth Percentage: 66.38%
Crown Depth: 15.34%
Pavilion Depth: 47.45%
I''ve been looking for quite a while, and this stone looks spectacular to me. Jonathon has been really wonderful, and very pleasant to work with.
I''m a bit apprehensive that looking at so many non ideal ones, my judgment has been compromised
-In the Diamond 1 picture, the lower left windmill and lower left corner table look to be longer than the rest. In the Microscopic 1 pic, you can see it in the upper right hand side. (it is more evident if you save the image then rotate). Is this an issue, or am I nitpicking?
-The initial Sarin 3D had the windmills tapering off to lines towards the culet (see Diamond 2 pic).
-The initial Gem Advisor had this performing at poor for all tests
Apart from the Asset and updated reports, do I need anything else? I do think this is an amazing stone, just wanted to make sure my eyes have not failed.
Thank you for your advice & opinions!
Does the Asscher below get everyone''s stamp of approval? Video and updated Asset, Sarin, & Gem Advisor reports will be posted tomorrow.
http://goodoldgold.com/diamond/4178
Carat Weight: 1.55ct
Color: F
Clarity: VS2
Polish: Very Good
Symmetry: Excellent
Fluorescence: None
Girdle: 3.32%
Culet: None
Lab Report: GIA
In House: Yes
Width: 6.48mm
Length: 6.49mm
Depth: 4.30mm
Table Percentage: 58.80%
Depth Percentage: 66.38%
Crown Depth: 15.34%
Pavilion Depth: 47.45%
I''ve been looking for quite a while, and this stone looks spectacular to me. Jonathon has been really wonderful, and very pleasant to work with.
I''m a bit apprehensive that looking at so many non ideal ones, my judgment has been compromised

-In the Diamond 1 picture, the lower left windmill and lower left corner table look to be longer than the rest. In the Microscopic 1 pic, you can see it in the upper right hand side. (it is more evident if you save the image then rotate). Is this an issue, or am I nitpicking?
-The initial Sarin 3D had the windmills tapering off to lines towards the culet (see Diamond 2 pic).
-The initial Gem Advisor had this performing at poor for all tests
Apart from the Asset and updated reports, do I need anything else? I do think this is an amazing stone, just wanted to make sure my eyes have not failed.
Thank you for your advice & opinions!