ering & wedding band together - question

[bonitachyc]

how can i attach the two rings so that they will not shift and move their own separate ways like pictured below?

(i''m new, i''ve tried to post this about 3 times and it keeps getting erased!

!)

 

[bonitachyc]

(okay...that worked...sorry the original post isn''t complete, the picture wasn''t coming up in the preview screen and i didn''t know if the pic would post or not!)

this is a picture of the back of the rings, when adjusted correctly in the front. (the wedding band has diamonds half way around)

apologies for the lousy picture quality, [it''s from my cell phone cam]

 

[bonitachyc]

finally, this is a picture of the wedding band and ering correctly positioned.

 

[mrssalvo]

you can have them soldered together...

 

[Steel]

Do you think your rings are loose at the point where they rest for normal wear?

Do you think this is what causes the spin?

If so perhaps a set of sizing balls may help?

 

[beau13]

Mine do the same occassionally, it helps if you put the band on first, then the solitaire...you''ll probably find the heavier ring on top will stop this spinning. They may need to be sized down even a quarter of a size to stop spinning...mine don''t spin now that I sized them down just a teeny wee bit!

 

[surfgirl]

You could have them soldered together but if the ering is too big, it''ll still put the entire ring over to one side. Is there a reason you haven''t had the ring sized to fit you better?

 

[Diamond*Dana]

I had the very same issue corrected with sizing balls.