Engraving on the inside of ring- Question!

[WishfulThinking]

Hello everyone!

I have what I hope is a fairly simple question about engraving on the inside of engagement rings. Is there a specific mm band width range that is necessary for engraving to be done?

I am really in love with the legato micro pave engagement ring setting from Whiteflash, but I am also in love with the idea of having a special engraving on the inside of my band. Since the band is thin at 2mm, would it even be possible to do engraving on it?

I imagine that different people who do engravings probably have different guidelines for suggested width and whatnot, so I''m looking for perhaps more of a general idea of what to expect than anything else.
If people who have thin bands, especially 2mm, and engraving, please chime in and help a girl out!

Also, does anyone have suggestions about who does a good job with engravings? Does Whiteflash happen to do them?

Thanks in advance!

 

[KtIceRN]

Here is proof that it is possible!!

WF did the engraving as well as the small melee on the inside. It came out very nice.

ETA: this is the WF legato micropave with a few custom tweaks.

 

[WishfulThinking]

Oh, thank you so much!!

Your ring is lovely, and the engraving, little heart prongs, and little surprise diamonds on the inside are such pretty touches!