I want to get everyone's opinion on the custom split shank ring that I have been working on with Bridgette Durnell over the last couple of weeks. I am very happy with the drawings that she has done for me, however, I am unsure of some of the finer details such as size of melee being used. Any feedback would be welcomed.
the details that they have provided me are as follows:
-the split will go to 2 or 2:30, at which point the shank will merge into a single band.
-melee will extend to "4 o' clock" on the shank
-they recommended 3/4 pt melee in the split part of the band
- 1 and 1/2 pt melee where shanks merge
-shank below the split will measure 2.5 mm (seems slightly thick to me, as only using 1 and 1/2 melee)
-millgrain boarding all melee
-in addition to the diamonds shown in the V bar of the head, there will be 3 stones on either side of the shank where the prongs merge with the shank ( the part of the band that sits just above the top of the finger )
may be forgetting some details but hoping for opinions.
the details that they have provided me are as follows:
-the split will go to 2 or 2:30, at which point the shank will merge into a single band.
-melee will extend to "4 o' clock" on the shank
-they recommended 3/4 pt melee in the split part of the band
- 1 and 1/2 pt melee where shanks merge
-shank below the split will measure 2.5 mm (seems slightly thick to me, as only using 1 and 1/2 melee)
-millgrain boarding all melee
-in addition to the diamonds shown in the V bar of the head, there will be 3 stones on either side of the shank where the prongs merge with the shank ( the part of the band that sits just above the top of the finger )
may be forgetting some details but hoping for opinions.
300x240.png)