viscera912
Shiny_Rock
- Joined
- Feb 15, 2004
- Messages
- 109
hello everyone,
This post is regarding programs used for custom settings. I am currently speaking with a prospective custom platinumsmith and I asked him what programs he uses for designs. He told me he uses Gem Vision and Image Dome, I was wondering if these are comparable to CAD as that is the only program I have seen here on PS. Another question is regarding a solder. He told me he uses a 1800 platinum weld seamless solder...what is that? I am not familiar with solders and I am just curious what that is. Also, he mentioned that when it comes down to the finished pieces he uses CAD-cam, is that the same thing as CAD that has been mentioned on this forum? Thanks for all replies!
Jason
ps. i will prob be getting a custom setting with plat and ruthenium
This post is regarding programs used for custom settings. I am currently speaking with a prospective custom platinumsmith and I asked him what programs he uses for designs. He told me he uses Gem Vision and Image Dome, I was wondering if these are comparable to CAD as that is the only program I have seen here on PS. Another question is regarding a solder. He told me he uses a 1800 platinum weld seamless solder...what is that? I am not familiar with solders and I am just curious what that is. Also, he mentioned that when it comes down to the finished pieces he uses CAD-cam, is that the same thing as CAD that has been mentioned on this forum? Thanks for all replies!
Jason
ps. i will prob be getting a custom setting with plat and ruthenium