CAD help provence gem

[jrzgrl1119]

I'm working on a new ring and id like some eyes on this. Inspo picture included

 

[jrzgrl1119]

 

[lovedogs]

Lovely! It looks like the side details (on the head of the stone--the ones opposite from the prongs) aren't quite right. But everything else looks amazing!

 

[Rfisher]

I'd be wary of the .9mm measurement at the bottom of the shank.
If you like the basket peeping out from under the stone in the face up view of the inspiration- it doesn't look like you'll get that from the looks of the CAD.

 

[jrzgrl1119]

Lovely! It looks like the side details (on the head of the stone--the ones opposite from the prongs) aren't quite right. But everything else looks amazing!

I noticed that

 

[jrzgrl1119]

 

[lovedogs]

eek! I didn't realize it was so thin (didn't even look!). Definitely make it thicker than .9! I'd say 1.5mm is the minimum for shank width, 2mm is safer.