Advice on Princess Diamond

[lost-in-translation]

Hello to all,

I have been surfing this website for quite some time, and frankly it''s addictive. There''s so much valuable information and so little time since I will be purchasing a diamond this week. Anyhoo, I need some advice on a princess diamond I am about to purchase. The spec''s are as follows:

Weight: 1.5
Width 6.32
Length 6.32
Depth 69.6%
Table 72%
Height 10.4%
Girdle Medium 2.9-3.9%
Pav. Ht 56.5%

 

[researcher]

I''m honestly not sure. What did Brian have to say (it looks like this is from WF)? To me, it looks as though there''s a lot of light leakage. The specs themselves look good (even though the table is bigger than the depth it still has a good crown). Have you called the stone in? Have you seen it in person? Hopefully an expert will respond!

 

[lost-in-translation]

Yes, it is from wf. Unfortunately, I have not seen the ring yet.

 

[Garry H (Cut Nut)]

That straight down leakage pattern is not as bad as it first looks. There are a number of the new aGS 0 proportions that have this leakage - but with the slightest tilt it goes away.

I would guess that this stone would make it for AGS AGS 0 light performance, but it may be marked down a notch for symetry. it looks pretty good to me.

And the spread is well within the AGS range for ''0''

 

[lost-in-translation]

Thanks Gary the info helped.