I like the tab prong size and the proportion of the side stones to the center stone. However, I would ask for CADs with just the shank going back to the original (20% smaller). What was the mm of the original shank at the widest point and what was the mm of the band at the narrowest?
I am asking for the CAD model backup of the latest render I posted above (with all the measurements). Also asked her to provide me with the CAD model with measurements plus render image of the alternative version with smaller side stones.
Below is the first original CAD. Does not appear to include width at widest point of shank. Original model had with tapering to 1.8mm on palm. I had her change that to taper to 2.0mm on palm based on initial feedback here (Amy also agreed this was a good change for durability reasons).