Asscher dimensions

[bigbling]

Hi, I''m new to this website. My girlfriend is always on here. I''m looking for the "accurate" dimensions of an asscher cut. Could someone please help. Thank you.

 

[strmrdr]

from another thread here is what I look for:

An asscher is one of the hardest diamonds to pick from without someone looking at it in my opinion.
Either a trusted vendor, appraiser or yourself needs to eyeball the diamond.

I look for a table in the high 50s very low 60s.
Depth between 65% and 75%
crown 10%-15% <--- very important to add fire.
LW ratio as close to 1 as possible.
clipped cornered square vs more octagonal is personal preference Iv seen some awesome ones both ways and like the clipped cornered square look better.
Then it comes down to all eyeballs.
Are the squares well defined and concentric?
Does it have the 10 mile deep look under indirect lighting?

Id say that better than 95% of them will fail the last 2 tests in my somewhat limited experience.

I also want to add that vg or better on polish and symetry is another thing I look for.
To me it shows that the cutter took better care in cutting it and there is a better chance of the rest being right.
That isnt always the case but its something to think about.