michelles85
Shiny_Rock
- Joined
- May 5, 2015
- Messages
- 104
Hi all,
My custom halo ring was made by DK but i have a question. I noticed the shank is uniformed all around at 1.8mm including the bottom part of shank without diamonds. I have noticed that other peoples rings get thinner towards the plain rear shank area. Should I have DK slim it down a bit? I couldn't really pick it up in photos but it's a lot more noticeable in person. I guess also because i imagined the shank to be more rounded? rather than look like the edges are angled. But i am very happy overall and am not being picky. It just appeared funny looking when i took off my ring so just confirming.
Any inputs would be greatly appreciated.
Thank you so much again!
My custom halo ring was made by DK but i have a question. I noticed the shank is uniformed all around at 1.8mm including the bottom part of shank without diamonds. I have noticed that other peoples rings get thinner towards the plain rear shank area. Should I have DK slim it down a bit? I couldn't really pick it up in photos but it's a lot more noticeable in person. I guess also because i imagined the shank to be more rounded? rather than look like the edges are angled. But i am very happy overall and am not being picky. It just appeared funny looking when i took off my ring so just confirming.
Any inputs would be greatly appreciated.
Thank you so much again!