Custom Ring Specs/Requirements - Please Review

[zuwood]

Probably could have added this in my last post but oh well.

Here's my specs/requirements for a custom ring set that I want to have made, do you guys see anything else that I left out or need to clarify

E - Ring
Metal - Platinum
Style - 3/4 eternity shared prong (http://www.whiteflash.com/gallery/d...ss-cut-shared-prong-engagement-ring-12301.htm) with ACA melee
Width of band - 2.5 mm
Head - 6 prong basket, same style as picture (http://www.whiteflash.com/engagemen...e-du-couer-solitaire-engagement-ring-1562.htm) with two contact points (http://www.whiteflash.com/gallery/d...tom-6-prong-diamond-engagement-ring-32101.htm) including the curved section under the center stone
Size - 7

Key Design Features
* Must allow matching wedding band to fit flush
* Would like the center stone some what low profile (not a great distance from the top of the center stone to the inner diameter of the band), seems that the 2 contacts points of the head make this possible, overall profile doesn't have to be extremely low to where the notch under center stone is extremely thin or the distance between the two contact points are far apart
* Head prongs thin, but sturdy,clawed
* Accommodate center stone that will be 1 - 1.25 carats
* Would like side stones to stop at the same position as on wedding band

Wedding Band
Metal - Platinum
Style - 3/4 eternity shared prong (this style) with ACA melee
Width - 2.5 mm
Size - 7

Key Design Features
* Fit flush to e-ring
* Would like side stones to stop at the same position as on e-ring

 

[zuwood]

From reading hundreds of post about shared prong rings I decided to add

* Side stone girdles should be slightly recessed from the width of the e-ring and w-band to

Anything else to that I should mention or add

 

[tyty333]

I'm not getting a clear picture of the head you want.

Are you saying you want a basket like the first (head) setting you linked but also the "W" like undergallery on the
second (head) setting you linked? 6 prongs, right? If I'm reading that correctly seems like its going to be lots of metal and
kind of busy (especially if you want it set low).

I really like the head on the second (head) setting you linked.

(when I say "head" I'm speaking head versus the very first link that you posted which is related to the shank)