CAD Check from Provence - Inspiration pictures included

[not_nerdy]

Hi everyone. I received a CAD drawing and would appreciate your help in modifying to make sure I get the best ring. I was provided a CAD combined with the matching wedding band. The center stone is 6.5mm H&A, metal is PT950.

The CAD:


I am planning to make the ring bottom 1.8mm instead of 0.9mm.

Also I was thinking I would add 2 more prongs, though I do like the look of it as it is.

I feel pretty good about the wedding band, but thought maybe it should be a bit wider as well. I do not know yet if there will be plans to solder them together.


The inspiration pictures are from https://www.ericdress.com/product/E...m-Plated-Round-Cut-Wedding-Ring-12842644.html:






Thanks for your help!

 

[bbk0885]

It's a little bit hard to tell because not all the measures I would expect to see are labeled on the CAD. Do you know what the thickness of the band is where the pave stones are? I have seen it recommended that that be at least 2mm for durability. I would personally ask for the pave to be a little bigger than 1mm, but that is a personal preference. It depends on what you like.