Post by Suspenders » May 7th, 2012, 5:55 pm
Hi everyone!

New to the forum. I've been doing a LOT of research on diamonds over the past few months and am ready to take the plunge.
I'm looking at a Round brilliant cut diamond with the following specs:
GIA certified 3X
F Colour
VS2
1.25K

On the GIA certificate, it states that there is a "knot" and in the diagram, it is shown from the top view somewhere in the middle.

I've read that a "knot" is something you'd want to avoid because it is one of the worst inclusions to have and could affect the diamond in the long run.

However, since it is a VS2, by definition, it hasn't reached the surface and thus, I think it should be okay.

Any thoughts on this?

Thanks for your help!