Hello All,
I am new to Pricescope but having read through some of the posts I think this will be a very helpful and supportive forum.
I had this ring custom made and I have a rare opportunity to make some modifications to the height of the setting if I wish. So, I would like some opinions please on whether the stone setting should be lowered so that the cutlet is closer to the band. It is about 1.8mm around from the band at the moment, I can lower it up to 1mm, leaving 0.8mm gap between the cutlet and the band. If I decide to lower the setting, the wraps will be further down each side of the band (hence further apart from each other) and might sit between the fingers when worn.
The table of the stone is exactly 7mm high at the moment.
What are do you think? Keep it the way it is? or lower it 1mm? or less?
Thank you all in advance for your help with this.
I am new to Pricescope but having read through some of the posts I think this will be a very helpful and supportive forum.
I had this ring custom made and I have a rare opportunity to make some modifications to the height of the setting if I wish. So, I would like some opinions please on whether the stone setting should be lowered so that the cutlet is closer to the band. It is about 1.8mm around from the band at the moment, I can lower it up to 1mm, leaving 0.8mm gap between the cutlet and the band. If I decide to lower the setting, the wraps will be further down each side of the band (hence further apart from each other) and might sit between the fingers when worn.
The table of the stone is exactly 7mm high at the moment.
What are do you think? Keep it the way it is? or lower it 1mm? or less?
Thank you all in advance for your help with this.